Display problem
have a Intel 2.8 Ghz HT processor with 865 GVHz Intel original mother board. Running with Windows XP professional . For last few days while starting windows, the screen goes heywire at log-in screen. I tried to boot it through Knoppix CD(Linux), it worked initially. After that even Windows started normally and I could work. Later it will not even boot through Knoppix. Display wont come. Sometimes a screen will appear with various choices of boot, e.g., Boot in Safe mode etc., Last known good configuration, start windows normally. However it will not boot further. After giving a days break I got the following message (quoted as it is)
Quote
INTEL DESKTOP BOARDS
Integrity to Build on
BF865 10A.86A.0061.P17.0404211558
INTEL( R) Pentium( R) 4 processor, 2.80C GHz
DDR 320 - - > Operating in single-channel dynamic paging mode
240MB system RAM
Legacy Keyboard
. Detected
USB Legacy
Enabled
Fixed Disk O: 3M-S7380011A (Ultra DMA mode ATA/100)
AT AP 1 CD Rom 4M SAMSUNG CD-R/RW DRIVE SW-252
ATAPI CD ROM 4S-SAMSUNG DVD-ROM SD-616E
CMOS/GPNV Checksum Bad
Press <F4> to run setup
Unquote
I ran setup. But problem remains. Sometimes horizontal lines are appearing in the Intel display boards while booting and then hangs.
Can anyone please tell me what the problem is and its solution?
|