RAM dosn't fit.

[tarleton]

Hello all,
I'm trying to put 1 gb stick of 1 gb DD3 pc3200 module 64x8 (k-1806 accutek) This is just all the information written on the side of the stick of ram. Please help

[Disk_Contented]

In new boards, memory is sometimes a tight fit, but if the RAM is rocking in the slot, then don't force it. You will cause damage.
Does your board support DDR3?

[netking]

never force the RAM as some times the clip may be damaged.
try sliding it slowly since it will lock it self if u have purchased the proper set

[netking]

never force the RAM as some times the clip may be damaged.
try sliding it slowly since it will lock it self if u have purchased the proper set.

[RabidDog]

Yes u should be sure your board supports DDR3 before u try and put it in. DDR3 is a fairly new technology and only the newest motherboards support it. Check your mobo's manual if you arent sure what kind of memory it supports. It will tell you.

I also noticed u said DD3 PC3200.... DDR3 doesnt come in PC3200, that would be regular DDR.... so it prolly isnt DDR3 if it says that... Again...check your manual.

[wadders]

could be back to front... my mate made the mistake of putting it in the wrong way round and it wouldnt fit.