Open your Internet Explorer home page and in the address bar type in
http://(then your ip address given to you by your router. If you dont know
it follow this thread: Start/All Programs Accessories/Command Prompt.
In Command Prompt type in ipconfig(spacebar)/all - now dont type in the
spacebar but hit your spacebar then forward slash/all. your ip address will
If we have the same router it should be 192.168.1.1
So it should be http://192.168.1.1 - when you click go an NR041 window should pop up.
Now in the Password box type in the password given to you by Lynksys or if
we have the same it should be admin <--- (in lowercase). You wont need to
type in a Username
When the Cable/Router Basic Setup window opens it may open to the Basic
Settings so if this is the case click on the Advanced Settings tab.
When the Advanced Settings window opens click on the Forwarding tab. - The
Advanced Settings may automatically open at first so the better.
Now when the Forwarding window opens, on the left hand of that window go
down to Customized Applications.
In the box below Customized Applications type in a title called Port 113
Now in the following boxes to the right you should type this:
Ext. Port - 113
Protocal TCP - put a check in this box by clicking on it.
Protocol UDP - leave blank.
Int Port - 113
IP Address - 192.168.1.250
Enable - put a check in this box by clicking on it.
Now click on the Apply button below.
Now go to grc.com and do a port scan and walla your port 113 will now be in